Zentralverrieglung

[sihui]

Original von jeepfürst
Das projekt würde mich auch interessieren.
herbert

Bei mir hat es nach dieser Anleitung wunderbar geklappt:

you will need a test light. The diagram above is the one you get with the kit. I only wanted the lock and unlock feature. I also connected the parking lights to blink. If you want the horn and anything else you are on your own. 1. Remove the drivers side kick panel 2. Find the light blue and black wire that go into the door. 3. Cut the blue wire. use the test light to find the hot side of the wire you just cut. You will have to activate the door lock switch to make one end of the wire hot. 4. Connect the green/black wire to the hot side. 5. Connect the white/ black wire to the other end of the blue wire that you cut. 6. Next cut the black wire and find the hot side with your tester. (activate the switch like before) 7. Connect the blue/black wire to the hot side of that black wire. 8. Connect the brown/black wire to the other end ofthe wire that you cut. 9. The violet and violet/black wires are already tied together near the plug end. Connect that to a hot at all times wire. 10. Connect the red to the same hot at all times wire. 11. Connect black to ground. 12. Connect the white to a parking light wire. I tapped into the brown wire that goes to the light switch. that is all I hooked up. you dont need any other wires. Not even the yellow unless you are hooking up other stuff. Hope this helps

Ich habe eine Viper 211 damit verbaut, allerdings nur die reine Verriegelungsfunktion, kein weiterer Schnickschnack wie blinkende Leuchten oder sonstiges.

Gruß, Sigi